Fire call at Culver's Champlin found no fire
Fire & ArsonResponders checked a report near Culver's in Champlin; no fire was found. Thermal imaging showed no heat, and crews cleared after inspection.
Audio|Source: Anoka County Police and Fire
01:58
Transcript:
Checking a vehicle walkout in Andover. Did you have a copy? About 203. All three clear. (name withheld) dispatch, (name withheld) (name withheld), Chief 3-in-1 arriving Culver's. Small bathroom restaurant is showing from ABC or D building not evacuated. Chief 3 will be on investigating. Culver's command will be on investigating. 1 A.80400 block of Riverdale. 6,400 block. (name withheld) engine 1-2-3 arriving, nothing showing on the A, B, CED, UF, command, 1124. 1124. 1124. (name withheld) Dispatch, (name withheld)-(name withheld) (name withheld)'s command. No problems here. We'll be unseen resetting. Can't phone call for command, copy, no problem, zero on the retainer, or so on 25. In traffic? May 14. (name withheld), the dispatch, one of green command update. What are green command? (name withheld), (name withheld), (name withheld), 298. Pulling through parking lot of hyperbath, dollar tree. Feet Parish. Central. (name withheld) 26. Again, fire is out. Thermal imaging camera[2] indicates no fire. The electrician and then the inspector on their way. Command[1] is terminated, all in the unit, (name withheld). (name withheld). Fires out, thermal engine showing nothing. Electric and then a inspector on the way all units clear. (name withheld) 26. One lymph in point. One lymph in 20.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
Command: Incident command established
[2]
Thermal imaging camera: Use of thermal imaging to check for heat/fire
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near Commerce Dr N, Champlin, MN 55316
Correct
Incorrect
