Fire alarm triggers response at townhome building


A fire alarm went off at a multi-story townhome building. The smoke detector activated, but there were no signs of fire or smoke.
Audio|Source: Brazos County Area Fire and EMS
00:57
Transcript:
Show us in route to this call our MDG Sound. Still alarm[1], engine through, fire alarm, 2910 Town Square Avenue, apartment 210 between Boonville Road, and High Point Drive Fox 416, Engine 3, Fire Alarm, 2910 Town Square Avenue, apartment 2103 between Boonville Road and High Point Drive, Box 416, respond on Brian Fire Channel 2, Brian Fire Channel 2. 3. You're in RAPU, a fire alarm of a townhome multi-story building. It's a smoke detector going off, unknown area zone, or room activated. There's no flames or smoke visible.
Police codes explained
The following codes appeared in the transcript and are explained below:
[1]
Still alarm: Initial fire alarm where no flames or smoke are reported
Disclaimer:
This was transcribed by AI and may contain errors. Please verify the information independently.
Location mentioned:
Near Town Sq Ave, Bryan, TX 77802
Correct
Incorrect